Dnr800 Series Rear Panel - FLIR DNR800 Series Instruction Manual

4

DNR800 Series Rear Panel

1. Power Input: Connect the included AC power cable.
2. ON / OFF Switch: Turns the NVR on or off.
3. PoE Ports: Connect IP cameras. Integrated PoE (Power Over Ethernet) ports provide
power to cameras and video connection to NVR.
4. LAN: Connect a CAT5 RJ45 Ethernet cable for local and remote connectivity.
5. USB Ports: Connect a USB mouse (included) or USB thumb drive (not included) for
data backup or firmware updates.
6. eSATA: Connect a self-powered external eSATA HDD (not included) to extend the stor-
age capacity of the system or for data backup.
7. HDMI: Connect to an HDMI monitor or TV (not included) to view the system interface
(menu options only available on HDMI1 port).
8. VGA: Connect a VGA monitor (not included) to view the system interface.
9. MIC IN/OUT: RCA input and output for 2–way audio.
NOTE
Audio-enabled IP cameras (not included) are required to use audio recording. You cannot record
audio from the input (e.g. microphone) connected to the MIC IN port.
10. RS232: Service only; not supported.
11. Alarm Block: Connect alarm/sensor devices (not included).
#LX400085; r. 1.0/38426/38427; en-US
7