Power Test - CyberData 011403 Quick Start Manual

3.0 Power Test

3.1. Plug in the CyberData device and monitor the LED activity on the front of
the device during the initialization process. See the following figure:
Link/Network Activity (Link/Act.) LED
(GREEN)
3.2. The Power (Pwr) LED is
GREEN Status LED and the
immediately. The Link/Network Activity LED blinks to indicate network
traffic.
After about 20 seconds the
that the board is fully booted.
If there is no DHCP server available on the network, it will try 12 times with a
three second delay between tries and eventually fall back to the
programmed static IP address (by default 192.168.1.23). This process will
take approximately 80 seconds.
3.3. When the device has completed the initialization process, press and hold
the RTFM switch for 3 seconds to announce the IP address.
This concludes the power test. Go to
Configuration File
Quick Start Guide
Link / Act.
GREEN
Retrieval".
Power (Pwr) LED
(BLUE/GREEN)
Power
for 802.3af and is
GREEN Power (Pwr) LED come on
GREEN Status LED will blink twice to indicate
Section 4.0, "InformaCast
Status
Status LED
(GREEN)
BLUE for 802.3at. The
931975A