Vfo Frequency Linkage; Wide/Narrow Band; Cross Band Repeat; Lcd Backlight - AnyTone AM-580 User Manual

VFo FRequencY linkAGe

Enable this function, the adjustment for any band of VFO frequency,
will bring same frequency change to both bands. Adjust one gear, the
frequency for both bands will increase or decrease one step size value.
11
Press key to enter function menu.
21
Turn the Main band selector knob to
choose No42 menu. The LCD displays "VFOTR"
31
Press the Main band selector knob to enter function setup.
41
Switch the Main band selector knob to choose wanted value.
Available Values: ON, OFF.
51
Press the Main band selector knob or
key to store value and back to function menu. Press
selector knob for over 0.5 second to store setup and exit.
This function is only valid when both bands work on VFO mode.
NOTE

wide/nARRow bAnd

11
Press key to enter function menu.
21
Turn the Main band selector knob to
choose No43 menu. The LCD displays "WIDNAR"
31
Press the Main band selector knob to enter function setup.
41
Switch the Main band selector knob to choose wanted value.
NARROW: Narrow band (12.5KHz)
51
Press the Main band selector knob or
key to store value and back to function
menu. Press key or hold selector knob
for over 0.5 second to store setup and exit.

cRoSS bAnd RepeAt

Set the left band and right band as VHF (136~174MHz) and
UHF(400~520MHz)then turn off this function will enable Cross Band
repeater function.
11
Press
21
Switch the selector knob to choose No 44
function. The LCD displays "X-RPT"
31
Press the Main band selector knob, the
LCD displays "XSTART".
41
Press the Main band selector knob, the radio prompt "DU" and the
LCD displays "RPT", the corss band repeat function is on.
key or hold
Press
NOTE

lcd bAckliGht

11
Press
21
Turn the Main band selector knob to choose No. 45-47 menu. The
LCD displays "COL RED","COL GRN","COL BLU"
31
Press the Main band selector knob to
enter function setup.
41
Switch the Main band selector knob to
choose wanted value.Each color (Red,
blue, Green) with 32 brightness levels.
51
Press the Main band selector knob or
key to store value and back to function
menu. Press
for over 0.5 second to store setup and
exit.

keYpAd bAckliGht bRiGhtneSS

General Setting
key to enter function menu.
will turn off cross band function.
key to enter function menu.
key or hold selector knob
7
28
580