Basic Operations; Switching The Power On/Off; Adjusting The Volume; Switch Between Vfo And Channel Mode - AnyTone AT-588 User Manual

6

Basic Operations

Switching The Power On/Off

according to the option selected during
installation Press the
ignition key to ACC (speed up) or ON (startup)
position to power on radio . Press the
for 1s or turn the ignition key to OFF position
to turn off.

Adjusting The Volume

Turn the VOL knob clockwise to increase
the audio level, counterclockwise to decrease.
During communication, volume can be adjusted more accurate.
12

Switch between VFO and Channel mode

In standby, press key or Microphone's
key until appear , this indicates current
channel in channel mode. Repeat above
operation to switch between Frequency mode
(VFO) and Channel mode.

Adjusting Frequency/Channel THROUGH SELECTOR KNOB

1.
Under frequency (VFO) mode, you can
change the current frequency to the
desired one through selector knob; Turn
clockwise to increase frequency; turn
counterclockwise to decrease. Every
gear will increase or decrease one step.
Press key, the decimal point of
PWR KEY
switch or turn the
key
Frequency Frequency
decrease increase
Dial
frequency in screen will be auto-hidden. In this status, turn selector
knob or Microphone [
frequency quickly by 1MHz step .
2.
Under channel mode, you can change the current channel to the
desired one through selector knob, clockwise turn to the forward
channel, anticlockwise turn to the backward channel. In relative
working mode, Microphone's [
Min Max
function for adjusting frequency and channel.
Volume
Volume
5k, 6.25k, 8.33K,10k, 12.5k, 20k, 25k, 30k and 50k total nine step size
available for this radio.

Receiving

Volume Knob
When the channel you are operating is
called, the screen shows
intensity, in this way, you can hear the calling
from transmitting party.
If the transceiver has set at higher squelch level, it may fail to hear the calling.
When the channel you are operating is called,the screen shows BUSY
and field intensity,you can't hear the calling from transmitting party,it
means current channel receives a matching carrier but unmatching
signaling(Refer to CTCSS/DCS encode and decode or Optional Signaling
setup).

Transmitting

Press and hold
key to return standby status,Then press and hold [PTT] key to speak
into microphone.
/ ] key will increase or decrease
/
and field
key or press MIC's key to monitor for a while
Release
] key has same
or press Mic's