On/Off Switch; Circuit Breaker - Peavey PVXp 10 DSP Operating Manual

LOWER REAR PANEL
ON-OFF SWITCH (1)
This rocker switch supplies AC power to the PVXp
position is with the left side of the switch pushed "in" or nearly flush with the rear panel.

CIRCUIT BREAKER (2)

The unit is AC power line protected from overloads and fault conditions with a 5-amp circuit breaker.
This breaker should not trip unless there is a fault in the amplifier circuitry or an abnormal operating condition,
which causes excessive mains current to flow. If the breaker trips, set the Power switch (3) to OFF, and after
waiting a brief period of time for the breaker to cool, reset the breaker.
If the circuit breaker trips, the center button will pop outward approx. 1/4", and can be reset by pushing upward
and inward. Under normal (not tripped) conditions, the center button is relatively flat.
If the unit continues to trip the breaker, or trips it immediately after being reset, do not keep resetting it, the
system should be taken to a qualified Peavey Service Center for repair.
IEC POWER CORD CONNECTION (3)
This receptacle is for the IEC line cord (supplied) that provides AC power to the unit. It is very important
that you ensure the PVXp™10 DSP has the proper AC line voltage supplied.
Please read this guide carefully to ensure your personal safety as well as the safety of your equipment. Never
break off the ground pin on any equipment. It is provided for your safety. If the outlet used does not have a
ground pin, a suitable grounding adapter should be used and the third wire should be grounded properly. To
prevent the risk of shock or fire hazard, always be sure that the mixer and all other associated equipment are
properly grounded.
1 2
10 DSP when switched to the ON position. The ON
™
3