Specifications - Peavey PVXp 10 DSP Operating Manual

SPECIFICATIONS

Frequency Range, 1 meter on-axis, swept-sine in ½ Space environment: 52 Hz to 20 kHz
Frequency Response, 1 meter on-axis, swept-sine in anechoic environment: 65 Hz to 20 kHz (±3 dB)
Usable Low Frequency limit (-10 dB point anechoic): 54 Hz
Nominal sensitivity (1W @1M, swept sine input in anechoic environment): 96 dB (average)
Maximum Sound Pressure Level (1 meter): 122 dB SPL peak with music
Radiation Angle measured at -6 dB point of polar response: Nominal: 100 degrees horizontal X 50 degrees ver-
tical (Axis of the vertical main polar lobe is angled down 10 degrees, resulting in the angular pattern with respect
to straight ahead being +15, -35 degrees)
Transducer Complement: Heavy-duty 10" woofer with 2-3/8" voice coil & 50 oz. magnet, RX™10N 1" titanium
diaphragm dynamic compression driver
Box Tuning Frequency: 75 Hz
Electroacoustic crossover frequency: 3,100 Hz
Crossover type: Advanced DSP based filter also providing driver EQ, level matching, bass boost, limiting, com-
pression and subsonic filtering.
Crossover Slopes: 24 dB/octave (4th order) low pass, 24dB/octave (fourth order) high pass, Linkwitz-Riley filter.
Input Connections:
One combo female XLR and 1/4" phone jack providing balanced line-level operation from the 1/4" jack section,
and high-output dynamic microphone operation from the XLR section. Two summed RCA jacks provide an
unbalalaced input for connecting cd or MP3 players.
Output Connections: One male XLR and one 1/4" phone jack. The Thru jacks are intended for the use of link-
ing multiple PVXp™10 enclosures in a line or to provide a feed to a powered subwoofer, or other electronics that
needs to receive a full range version of the input signal.
Enclosure Materials & Finish: Black ABS plastic with textured surface, black powder-coated perforated grille.
Also available in white.
Mounting provisions: Unit has two sets of two widely spaced M8 inserts, one pair on the top, and one pair on
the bottom. Additional mounting points are a set of four M8 inserts on the top, and a set of four on the bottom,
which use the Peavey Versamount 70+ mounting bracket. Four rubber feet provide vibration free floor or stage
use, and a molded-in stand mounting cup is on the bottom.
Dimensions (H x W x D):
Front: 20 in. x 12.69 in. x 11.06 in. 508 mm x 322 mm x 281 mm