Advertisement
LOWER REAR PANEL
ON-OFF SWITCH (1)
This rocker switch supplies AC power to the PVXp
position is with the top of the switch pushed "in" or nearly flush with the rear panel.
FUSE (2)
To replace the fuse, be sure to remove the IEC power cord from the IEC socket. The fuse holder tray is
located beneath the IEC socket cavity. Pry the fuse holder tray out with a small flat blade screwdriver placed un-
der the center of the top edge of the fuse tray, and gently lever the fuse tray out. The fuse is held in a clip in the
fuse tray, and should be removed and replaced with a fresh 5 X 20mm 250V type fuse of the appropriate current
rating. A spare fuse should be located in a hollow compartment in the fuse tray, below and behind the clip, this
would be the one that is NOT clipped into the fuse tray clips.
Then, once the fresh fuse has been put in place, re-insert the fuse tray into the IEC connector assembly, and
make sure it is fully seated and flush with the outside of the IEC connector assembly.
It is recommended that to assure future convenience of having a spare, that a spare fuse be obtained and placed
in the hollow compartment at the earliest convenient time.
IEC POWER CORD CONNECTION (3)
This receptacle is for the IEC line cord (supplied) that provides AC power to the unit. It is very important
that you ensure the PVXp™ 15 DSP has the proper AC line voltage supplied.
Please read this guide carefully to ensure your personal safety as well as the safety of your equipment. Never
break off the ground pin on any equipment. It is provided for your safety. If the outlet used does not have a
ground pin, a suitable grounding adapter should be used and the third wire should be grounded properly. To
prevent the risk of shock or fire hazard, always be sure that the mixer and all other associated equipment are
properly grounded.
3
15 DSP when switched to the ON position. The ON
™
2
1
Advertisement
