Table of Contents
Advertisement
UPPER REAR PANEL
4
INPUT (4)
The line-level input is of the medium impedance balanced type. The jack is a combo female XLR and 1/4" TRS
connector. Sensitivity of this input is 0.48 volts for full output, when the MIC/LINE switch (6) is in the LINE
position.
Level (5)
Controls the gain or output level of the input signal. It is used to directly set the system output level for a given
input signal.
MIC/LINE switch (6)
Switches between LINE level gain (out position) and MIC level gain (in position). MIC position increases gain
33 dB to allow use of most dynamic microphones.
NOTE: Phantom power is not supplied on the INPUT (4) jacks.
THRU jacks (7)
These jacks are intended for the use of linking multiple PVXp™10 DSP's in a line or to provide a feed to a pow-
ered subwoofer, or other electronics that needs to receive a full range version of the input signal.
8
5
6
9
7
Advertisement
Table of Contents
