Table of Contents
Advertisement
Net Weight: 29 lbs.
(13.2 kg)
ELECTRONICS AND AMPLIFIER SPECIFICATIONS:
Internal power amplifiers (@120 VAC line):
Total of 510 watts peak available dynamic power
Woofer - 380 watts peak available dynamic power
Continuous Power*: 150 watts @ less than 1% distortion
Tweeter - 130 watts peak available dynamic power
Continuous Power: 50 watts @ less than 1% distortion.
* Before thermal pull-back activates.
Electronic Input Impedance (Nominal):
Line: 2.2 k ohms balanced (1/4"), 10 k ohms unbalanced 1/4"
Mic: 2.2 k ohms balanced (XLR) No phantom power available.
Input Sensitivity for Full Output (Level full CW): 0.48V RMS in the Line position,
0.01V RMS in the Mic position.
Infrasonic filter protection: 36 dB/octave roll-off
Nominal Amplifier Frequency Response: +0, -3 dB from 20 Hz to 20 kHz
Hum and Noise: Greater than 90 dB below rated power
THD and IM: Typically less than 0.5 %
Damping Factor: Greater than 100 @ 1000 Hz, 8 Ohms
Power requirements of Peavey PVXp 10 DSP System: Nominal 100 Watts, 100-240 VAC 50-60 Hz
*specifications and features subject to change without notice.
Advertisement
Table of Contents
