Table of Contents
Advertisement
IMPORTANT INFORMATION
•
If the motor is dragged to a low speed since the food is too thick or there
is too less liquid in the jar, and operates for a prolonged period, the
temperature monitoring system will trigger and stop the operation of the
motor. In this case, switch off and put the blender to a place with good
ventilation to cool down the motor temperature for approx. 35 minutes.
The system will reset and the blender can be used again.
•
During operation, close the lid tightly to avoid scalding due to spraying of
hot liquids.
•
Keep hands and utensils out of the container while the motor is running to
prevent the possibility of severe personal injury and/or damage.
•
When making hot beverage such as soybean milk, hot soup, please check
whether the lid is secured tightly to the jar to prevent it from falling. It is
advisable to start the operation at low speed setting and then increase the
speed gradually, or use the Pulse Drive mode.
•
When making sauces (e.g. almond sauce, jam and sesame sauce), stuffing
and nuts, put in between 2 and 3 cups of ingredients. The amount should
neither be too large or too little. Keep the blending time below 2 min. to
prevent any burnt smell due to overheating. Too much ingredients may lead
to overloading and overheating of the motor. In this case, wait till the motor
temperature falls before operating again.
•
Please put liquid and soft food before putting in hard food or ice cubes.
•
When the operation finishes, please wait until the blade assembly comes to
a complete stop before taking up the blender jar.
•
If you feel a scorch smell from the blender, stop the operation immediately.
It may be caused by the abrasion at the rubber cushion base if it is not
properly assembled.
•
When blending thick and sticky food using high speed, please start the
operation at low speed. If the turning is still idle, disconnect the power and
stir the blender jar using a rubber stirrer to drive out the air capsule trapped
in the food. Then close the lid and switch on to proceed the operation.
•
Do not operate for more than 10 minutes at a time.
TECHNICAL SPECIFICATIONS
Model No.
Voltage / Frequency
Rated Power
Dimensions
Net Weight
BPFD-1680MB, BPFD-1680MW
220-240V ~ 50-60Hz
1680 W
(H) 430mm (W) 205mm (D) 174mm
4.3kg
13
Advertisement
Chapters
Table of Contents
