Install Pedestals - HIKVISION DS-K3B802BX Series User Manual

3.2 Install Pedestals

Before You Start
Prepare for the installation tools, check the device and the accessories, and clear the installation
base.
Steps
Note
The device should be installed on the concrete surface or other flat non-flammable surfaces.
●
Make sure the device is powered off during installation and other operations.
●
The installation tools are put inside the package of the pedestal.
●
The dimension is as follows.
●
1. Prepare for the installation tools, check the components, and prepare for the installation base.
2. Drill holes on the ground according to the installation holes on the pedestals and insert the
expansion sleeves.
3. According to the entrance and exit marks on the pedestals, move the pedestals to the
corresponded positions.
Note
Make sure the installation holes on the pedestals and the base are aligned with each other.
4. Secure each pedestal with 8 expansion bolts.
Note
Do not immerse the pedestal in the water. In special circumstances, the immersed height should
be no more than 150 mm.
5. After installation, assemble the components and screws back to the pedestal.
DS-K3B802BX Series Swing Barrier User Manual
Figure 3-5 Dimension
9