Troubleshooting - BOMANN VS 7316.1 H Instruction Manual

then evaporates. Make sure that the defrost water
drain channel does not become clogged. A slight
formation of ice on the interior rear wall during opera-
tion is normal.
A permanently high power level can lead to in-
creased ice formation
wipe the interior of the appliance dry.
Changing the bulb
CAUTION:
Do NOT remove the cover of the light. The LED light
may be replaced / repaired in case of failure / defect
only by an authorized specialist.
Replacing the door hinge
If the appliance door starts to stutter, crack or jam
when you open it, it is probably due to a worn or
damaged hinge.
It is recommended to replace all door hinges at the
same time, otherwise the next repair will soon be
beckoning.
• Remove the contents of the appliance and the
movable interior parts.
• Tilt the appliance backwards and block it in this
position to prevent the door from sliding out.
• Loosen the hinge cover as described under
versing the door opening"
upper door hinge.
• Turn out the stand and disassemble the lower
door hinge.
• The respective hinge assembly is carried out in
reverse order.
→ set a lower power level and
and disassemble the
• Open and close the appliance door for a test run,
readjust the hinges if necessary. In any case,
make sure that the door fits tightly and accurately.
Replacing the door handle
A malfunction due to too active use, may cause
damage to the door handle.
• Loosen the screw cover caps.
• Unscrew the screws underneath and remove the
door handle.
• The door handle is mounted in the reverse se-
quence, see also
Before you contact an authorized specialist
Problem / cause / action
Appliance is not working properly or at all
- Check the power supply / temperature setting /
ambient temperature.
- Unblock the ventilation openings, install the ap-
pliance freely.
Loading is too warm
- Check the temperature setting / ambient temper-
ature.
- A large quantity of warm food has been stored in
"Re-
the unit in the last 24 hours.
- The appliance door is not closed properly, check
the door seal.
Loud noise during operation
- Check that the appliance is level.
"Operating noise"
- See
26
"Assembling the door handle"

Troubleshooting

.
.