Cleaning And Maintenance; Troubleshooting - BOMANN KSG 7282.1 Instruction Manual

Cleaning and Maintenance

WARNING:
• Always disconnect the appliance from the power
supply before cleaning and user maintenance.
• Do not use steam cleaners for cleaning the appli-
ance; moisture could enter electrical components.
Risk of electric shock! Hot steam could damage
the plastic parts.
• The unit must be dry before restarting operation.
CAUTION:
• Do not use a wire brush or other sharp, abrasive
items.
• Do not use any acidic or abrasive detergents.
• Do not damage the refrigerant circuit.
Cleaning the appliance including interior
• Clean the appliance interior, the exterior surfaces,
the accessories and the door seal regularly with
warm water and mild detergent; or with a clean,
damp microfiber cloth without cleaning agent.
• Remove for that the appliance content and stor-
age at a cool location.
• Clean the thaw water discharge channel / opening
carefully e.g. with a pipe cleaner.
• After everything was thoroughly dried, you can
restart the operation.
Defrosting
CAUTION:
Never use metal objects (e.g. knives) for removing
ice from the vaporizer. The vaporizer could be dam-
aged.
To achieve better cooling and to save energy, defrost
the device regularly.
• To start the defrosting process, disconnect the
unit from the power supply.
• Remove the loading and keep at a cool location.
• When the ice has melted, wipe the condensate
away and dry the appliance interior.
Changing the bulb
CAUTION:
Do NOT remove the cover of the interior light.
The LED light may be replaced / repaired in case of
failure / defect only by an authorized specialist.

Troubleshooting

Before you contact an authorized specialist
Problem Cause / Action
Unit is not ∙ Check the power supply / temper-
working ature setting / ambient temperature.
properly or ∙ Unblock the ventilation openings,
at all install the appliance freely.
Loading is ∙ Check the temperature setting /
too warm ambient temperature. ∙ Open the
door only as long as necessary.
Loud noise ∙ Check the appliance position.
during op- ∙ See the section "Operating noise".
eration
Water on ∙ Check the temperature setting /
the unit water discharge channel or open-
bottom ing.
Light does ∙ Check the power supply.
not work ∙ See "Changing the bulb".
NOTE:
If a problem persists after following the steps above,
contact your trader or an authorized technician.
19