Table of Contents
Advertisement
6.
From the rear of the computer, disconnect the speaker cable from the system board (1), and then push
the connector end of the cable through the hole (2) that allows the cable to route to the front of the
chassis.
7.
Remove two Phillips screws (1) that secure each speaker to the computer.
8.
Pull the speaker cable through the hole in the chassis (2).
9.
Remove the speakers from the computer.
To install the speakers, reverse the removal procedures.
20-models
The speakers are located at the bottom of the computer behind the speaker cover. Two separate speakers are
each secured by two Phillips screws.
To remove the speakers:
1.
Prepare the computer for disassembly (see
2.
Remove the stand (see
3.
Remove the rear port cover (see
Preparing to disassemble the computer on page
Stand on page
21).
Rear port cover on page
23).
21).
Speakers
43
Advertisement
Table of Contents
