Start-Up And Power Loss - Zennio EyeZen TP v2 Manual

EyeZen TP v2
To get detailed information about the technical features of this device, as well as on the
installation process and on security procedures, please refer to the corresponding
Datasheet, bundled with the original packaging of the device and also available at
www.zennio.com.

1.3 START-UP AND POWER LOSS

During the start-up of the device, the detection notification LED flashes red for one
minute before the motion sensor is ready.
Depending on the configuration, some specific actions will also be performed during the
start-up. For example, the integrator can set whether the detection channels should start
up enabled or disabled.
https://www.zennio.com Technical Support: https://support.zennio.com
5