Switching On The Device - AAT V-MAX mini User Manual

WARNING - Observe the maximum total permissible weight.
(Refer to chapter "Technical data")!
CAUTION - Always overcome kerbs/obstacles backwards (refer to chapter "Overcoming ob-
stacles").
CAUTION - Maintain sufficient distance to the edge of the kerb to avoid damage!
CAUTION - When using seat supports (cushions, etc.), ensure that the occupant is securely
seated to prevent the occupant from falling out or slipping!
NOTE - Never pull/lift by the operating unit of the
i
for this purpose. Use the pushing handles of the wheelchair.
NOTE - Do not drive backwards against walls with the anti-tip supports attached so as not to
i
damage the anti-tip supports. We recommend using the wheelchair manufacturer's anti-tip
supports.
i
NOTE - Do not pull the power cable during use!
NOTE - Before first start-up, the battery pack must be fully charged!
i
NOTE - The
V-MAX MINI
i
manually.
NOTE - Perform a visual inspection prior to each start-up! If parts are visibly defective or miss-
i
ing, contact the authorised specialist shop or the manufacturer!
NOTE - In the event of longer breaks, the automatic switch-off switches off the
i
after approx. 15 min. To become ready to drive again, switch off the battery and switch it on
again after approx. 1-3 seconds.

6 1 Switching on the device

i
NOTE - DO NOT operate the thumb throttle while switching on - Starting protection!
i
NOTE - The battery must be locked in place using the key for the battery locking device!
NOTE - The release switch must be turned completely to the right (closed point), otherwise the
i
drive will not receive a travel signal!
Please, switch on
only after the
V-MAX mini
occupant has taken his seat.
does not have a reverse gear. The wheelchair must be turned
the If necessary, turn the release
switch completely to the right.
If not yet done.
as it has not been designed
V-MAX mini
Switch on the V-MAX mini at
the battery.
V-MAX MINI
19