Advertisement

Quick Links

RESIDUE MANAGER ATTACHMENT
YETTER MANUFACTURING CO.
FOUNDED 1930
Colchester, IL 62326-0358
Toll free: 800/447-5777
309/776-3222 (Fax)
Website:
E-mail:
info@yetterco.com
2967-115A
2960 SERIES II UNIT MOUNTED
CONSERVATION COULTER
2565-327_REV_D
www.yetterco.com
FOR
06/2021

Advertisement

Table of Contents
loading

Summary of Contents for Yetter 2967-115A

  • Page 1 2967-115A RESIDUE MANAGER ATTACHMENT 2960 SERIES II UNIT MOUNTED CONSERVATION COULTER 2565-327_REV_D 06/2021  YETTER MANUFACTURING CO. FOUNDED 1930 Colchester, IL 62326-0358 Toll free: 800/447-5777 309/776-3222 (Fax) Website: www.yetterco.com E-mail: info@yetterco.com...
  • Page 2: Warranty

    WARRANTY Yetter Manufacturing warrants all products manufactured and sold by it against defects in material. This warranty being expressly limited to replacement at the factory of such parts or products as shall appear to be defective after inspection. This warranty does not obligate the Company to bear cost of labor in replacement of parts.
  • Page 3: Safety Precautions

    SAFETY A brief description of signal words that may be used in this manual: CAUTION: Used as a general reminder of good safety practices or to direct attention to unsafe practices. WARNING: Denotes a specific potential hazard. DANGER: Denotes the most serious specific potential hazard. SAFETY PRECAUTIONS You can make your farm a safer place to live and work if you observe the safety precautions given.
  • Page 4: Operation Precautions

    - MACHINE OPERATION IMPORTANT: failure to properly set the planter frame height and levelness can result in less than successful operation of the planter and the Yetter product and may result in damaged equipment. All operators should read and thoroughly understand the instructions given prior to using the Yetter product.
  • Page 5 PLANTER ADJUSTMENT...
  • Page 6 INSTALLATION Remove the upper ½” x 2 ½” bolt which attaches the unit coulter arm to the bracket through the slot. The two flat washers are no longer required. Save the lock nut for later use. CAUTION: DO NOT USE SPACER STRAP ON COMBO ARM W.A. AS A HANDLE, FINGERS MAY BE SERIOUSLY INJURED ON SHARP EDGE OF BLADE.
  • Page 7: Parts Identification

    PARTS IDENTIFICATION 2967-115A-ST-FW...
  • Page 8 PARTS IDENTIFICATION 2966-140-ST-FW 2966-140-BW-FW...
  • Page 9 PARTS IDENTIFICATION 2966-141-FW...
  • Page 10 NOTES...
  • Page 11 NOTES...
  • Page 12 2565-327_REV_D  06/2021...

Table of Contents