Welbilt Frymaster McDonald's LOV BIGLA30 Gen II Series Installation, Operation And Maintenance Manual page 90

Display
RINSE AGAIN; YES/NO
POLISH; YES/NO
OQS; YES/NO
POLISHING
FILL VAT; YES
FILLING
TPM...X
TPM value
FILLING
IS VAT FULL; YES/NO
OFF
Pre-Filter Maintenance
The pre-filter (Figure 1) installed with the kit
requires regular maintenance. Every 90 days, or
more frequently if the flow of oil slows, remove the
cap with the supplied wrench and clean the
attached screen.
1. Wearing protective gloves use the supplied
wrench to remove the cap from the pre-filter
(Figure 2).
2. Use a small brush to clear debris from the attached screen (Figure 3).
3. Clean under a water tap and thoroughly dry.
4. Return the cap to the pre-filter housing and tighten.
DO NOT remove the pre-filter cap when a filter cycle is under way. DO
NOT operate the filter system with the cap removed. Wear protective
gloves when handling the cap. The metal and the exposed oil are hot.
Action
Press checkmark under YES if additional rinsing is necessary; press X
under NO if no additional rinsing is needed.
Press the checkmark under YES.
Press the checkmark under YES to run the oil quality test.
None required
Press checkmark under YES.
None required.
None required.
None required.
None required.
Verify vat is full and press checkmark under YES. Press X under NO if
the vat is not full and the pump will run again.
Leave fryer off or return to service.* DISPOSE YES/NO is displayed
when the fryer is turned on and returns to temperature if the TPM value
exceeded 24.
WARNING
D-2
Figure 1
Figure 3
Figure 2