Welbilt Frymaster McDonald's LOV BIGLA30 Gen II Series Installation, Operation And Maintenance Manual page 25

1. Open the cabinet and slide the JIB from
the cabinet (see Figure 4).
Figure 4
3. Place new JIB upright and remove the
cap and foil seal (see Figure 6).
Figure 6
WARNING:
HOT or USED oil to a JIB.
3.4.4 Bulk Oil Systems
Instructions for installing and using bulk oil systems are found in Appendix A located
at the rear of this manual.
2. Remove the cap and pour any remaining oil in the
4. Put the tube in the new full container (see Figure 7).
5. Slide the JIB onto the shelf inside the fryer cabinet (as
Do not add
6. Press the JIB reset switch to turn the JIB LED on the
container into all fry vats equally (see Figure 5).
Figure 5
Figure 7
seen in Figure 4).
front of the fryer off (see Figure 8).
3-6
Figure 8