Advertisement
LCD Display
The diagram to the right shows all available icons of the front
panel LCD for all SSG models. Refer to the LCD symbols in the
left-hand column, below for their functional definition:
Utility Power Status: Line cord icon indicates utility
power is within specification.
PFC Status: Sine wave icon indicates the input power
factor correction (PFC) is functioning properly.
Inverter Status: Generator icon indicates the inverter is
functioning properly.
Charger Status: Gas pump icon indicates the charger is functioning properly.
Output Load %: The greater the load, up to three vertical bars will be illuminated at the top of
the weightlifter icon. Each bar represents approximately 25% of the UPS output rating.
Battery Mode: Scissor lift icon indicates the UPS is in battery mode.
Battery Level: Battery cell icon indicates the battery capacity. The greater the battery capacity
available, the more internal bars will be illuminated. Each bar represents 25% capacity.
Fan in high-speed mode: HS fan icon indicates fans are in high-speed mode.
Fan in medium speed mode: MS fan icon indicates fans are in medium speed mode.
Fan in low-speed mode: LS fan icon indicates fans are in low speed mode.
BIT Window: The bit window displays programmable settings and fault condition error codes.
Audible Alarm: Speaker icon indicates the audible alarm is on.
Test: Test icon flashes indicating a battery self-test is being performed.
UPS Fault Condition: Exclamation point icon indicates an alarm condition exists.
Green Mode: Bulb icon indicates the green mode function is enabled. It will flash when the UPS
has switched to green mode due to the UPS output load decreasing to less than 3% of the total
UPS output rating.
Metering: Seven segment display provides readings for voltage, current, temperature, applied
load and frequency reported from the UPS.
Display & Controls
17
Advertisement
