Xblitz A2 GPS Manual page 9

8. Micro-USB port (rear camera)
9. Reset button
10. Multi-pin connection
11. LED
12. Handle
13. Micro-USB port (camera charging)
14. Microphone
15. Speaker
03. MAIN FEATURES OF THE CAMERA
1. Operating modes. The camera has three modes of operation: recording
mode (video recording), photo mode (taking photos), and playback mode
(viewing footage recorded by the camera)
2. Loop recording. The camera divides the recording files according to the
selected time set by the user. When the memory card fills up the oldest
recording will be overwritten.
3. GPS. The built-in GPS module is responsible for displaying information about
the vehicle's speed and its current coordinates in the camera recordings.
4. G-Sensor. Otherwise known as an accelerometer. When the sensor is activat-
ed at the time of a shock (e.g. collision), the recording file is protected from
being overwritten. It is recommended that the lowest available value is set,
as at a higher value the camera may pick up shocks caused by unevenness of
the road, which can cause the memory card to become full.
5. Parking mode. When enabled, the camera catches a jolt from the car (for
example during a parking bump), turns on, and starts recording a short video
(recordings are automatically protected against overwriting). It is advisable
to switch this function off for the duration of the drive, as it may block loop
recording. Note: To ensure that the camera properly records a full-length
recording, make sure the battery level is sufficient, or leave the camera
under a constant power source.
6. Rear view camera. The included rear view camera captures the image
behind the car . Where it is installed depends on the user›s preference . The
camera is splash-proof and can be placed outside the vehicle .
7. Motion detection mode. When enabled and the camera is running left
under constant power when the lens detects movement, it will start
recording video .
04. BEFORE USE
1. The use of branded microSD cards is recommended.
2. Before inserting the card into the recorder, it must be formatted to FAT32.
3. The camera must be switched off when inserting the memory card,
9