Advertisement
INSTALLING DRAWER SYSTEM
To install your Drawer System you will need to remove the Jump Seats form your vehicle first.
Now with the Jump Seats removed,
( A )
Remove the Deck from the Drawer
System. To do this unscrew the ten M6
Countersunk Cap Screw from the Deck
with a 4mm Hex Key. As shown in the
diagram to the right. Retain the Screws
for reuse later.
( B )
Carefully place the Drawer System into the
vehicle and place the Deck back on to the
Drawer making sure that the Deck fits
between the left and right hand wheel arches.
Position the Drawer underneath the Deck so
that the Holes in the Deck line up with the
Screw Holes in the Drawer. With the holes
lined up, loosely screw two of the Counter
Sunk Cap Screws previously removed in
Step2A into the front two holes. Position the
Drawer System so that the Deck lines up with
the inside edge of the door jam, as indicated
by the arrow in the picture.
Remove the Deck again. Take care not to move the
( C )
Drawer
SSLD001_REV_A00
3
Advertisement
