Mitsubishi Electric FR-A862-05450-E Instruction Manual page 45

Communication connectors and terminals
Communication operation
• Using the PU connector enables communication operation from a personal computer, etc. When the PU connector is
connected with a personal, FA or other computer by a communication cable, a user program can run to monitor the inverter
or read and write parameters.
Communication can be performed with the Mitsubishi inverter protocol (computer link operation).
(For details, refer to the FR-A860 Instruction Manual (Detailed).)
2.7.2
Ethernet connector
Ethernet communication specifications
Item
Category
Data transmission speed
Transmission method
Maximum segment length
Number of cascade connection stages
Interface
Number of interfaces available
IP version
Connection cable
Use Ethernet cables compliant with the following standards.
Communication speed
100 Mbps
10M bps
Hub
Use a hub that supports transmission speed of the Ethernet.
44
INSTALLATION AND WIRING
100BASE-TX/10BASE-T
100 Mbps (100BASE-TX) / 10 Mbps (10BASE-T)
Baseband
100 m between the hub and the inverter
Up to 2 (100BASE-TX) / up to 4 (10BASE-T)
RJ-45
1
IPv4
Cable
Category 5 or higher, (shielded / STP) straight cable
Category 3 or higher, (shielded / STP) straight cable
Category 3 or higher, (UTP) straight cable
Description
RJ-45 connector
Connector Standard
100BASE-TX
10BASE-T