Ricoh AP610N Maintenance Manual page 84

Troubleshooting
Messages/Second
messages
SC2001
SD authenticatn.
failed
Setting change
in process
SSID not entered
Supply order
failed
Toner is almost
empty
Update Mode Err.
Power Off On
Waiting...
Warming up...
Description
An error has occurred in the
resident font RAM.
Authentication from the SD
card has failed.
During offline applications, set-
ting change is currently in pro-
cess.
When pressing View to confirm
an ID, this message indicates
no ID has been entered.
Supply order has failed.
The toner is almost run out.
The printer has failed to start
updating data.
The printer is waiting for the
next print job.
The printer is warming up or
toner is being supplied.
Solution
Turn the power off, and then on. If the
message appears again, contact your
sales or service representative.
Turn the power off, and then on. If the
message appears again, contact your
sales or service representative.
No action required.
Enter requested ID.
The use is required to reset the job.
Prepare a new toner cartridge. If the
Image Density gets too light, replace
the toner cartridge with a new one.
See p.40 "Replacing the Toner Car-
tridge".
Turn the printer OFF and then back to
ON.
Wait a while.
Wait until the panel display change
the [Ready].
84