Ricoh AP610N Maintenance Manual page 83

Troubleshooting
Messages/Second
messages
Replace
Toner Cartridge
Reset Fusing
Unit correctly
Reset Toner
Cartridge
Reset Tray #
correctly
Resetting Job...
ROM Update
Waiting for Data
ROM Update
Receiving Data
RPCS Graphic Error
SC XXX-X
Power Off On
If Error Reoccur
Call Service
Description
The toner cartridge is not set
correctly or toner is almost run
out.
The toner dust is full.
The fusing unit is not set cor-
rectly.
The toner cartridge is not set
correctly.
The toner cartridge is not set in-
stalled.
The input paper tray is not set
correctly.
#: tray number
The print job is being reset.
The printer is waiting for updat-
ed data.
The printer is receiving updated
data.
The graphics is not initialized
because the graphics memory
was not reserved. This error
rarely occurs unless the printer
detects the memory failure.
Please note that
"RPCS"(RICOH printer lan-
guage) is the same worldwide
and does not need to be trans-
lated.
An error has occurred.
Solution
Set the toner cartridge correctly.
See p.40 "Replacing the Toner Car-
tridge".
Prepare a new toner cartridge. If the
Image Density gets too light, replace
the toner cartridge with a new one.
See p.40 "Replacing the Toner Car-
tridge".
Set the fusing unit correctly, or set the
proper fusing unit.
Set the toner cartridge correctly.
See p.40 "Replacing the Toner Car-
tridge".
If the cartridge is installed, close the
front cover and turn the off power
switch and then on. If the message
appears again, contact your sales or
service representative.
Set the input paper tray correctly.
Wait a while.
Don't turn off the printer while it is wait-
ing for data.
Don't turn off the printer while it is re-
ceiving data.
Replace the installed memory.
Turn the power off, and then on. If the
message appears again, contact your
sales or service representative.
83