Ricoh AP610N Maintenance Manual page 11

Paper and Other Media
Enabled paper feeding tray Any input tray can be used.
Number of sheets that can
be set
Both-side printing
Additional cautions
Thick Paper
Paper thickness
Printer setup
Printer driver setup
Enabled paper feeding tray Bypass Tray
Number of sheets that can
be set
Both-side printing
Additional cautions
OHP transparencies
Printer setup
Printer driver setup
Enabled paper feeding tray Bypass tray
Number of sheets that can
be set
Both-sided printing
• Tray 1: 500
• Tray 2, Tray 3 (Paper Feed Unit Type 400): 500
• Bypass Tray: 100
❒ Make sure paper is not stacked higher than the upper limit
mark (T) inside the tray. Make sure paper is not stacked higher
than the paper guides inside the bypass tray.
Possible
When printing on 91 - 105 g/m
er to when printing on paper of 60 - 91 g/m
2
105 - 162 g/m (28 - 43 lb.)
Press [Paper Input] menu, [Paper Type] and then [Thick Paper] on the
control panel.
❒ The paper type selected using the printer driver overrides that
selected using the control panel.
Click [Thick] in the [Type:] list.
Make sure paper is not stacked higher than the paper guides in-
side the bypass tray.
Not possible
Print speed is slightly slower than when using plain paper.
Press [Paper Input] menu, [Paper Type], and then [Transparency] on
the control panel.
❒ The paper type selected using the printer driver overrides that
selected using the control panel.
Click [Transparency] in the [Type:] list.
Load only one OHP transparency at the same time onto the by-
pass tray.
Not possible
2
paper, print speed is slightly slow-
2
.
11