Ricoh Aficio CL5000 Setup Manual page 43

L L L L
Tighten the two screws that you
removed in step
controller board back into its
original position.
Use a coin to fasten it securely.
M M M M
Set the dustproof filter cartridge
that you removed in step
Important
❒ Do not shake the removed car-
tridge. It may cause dust to fall
off.
E E E E
to fasten the
ZESH753J
D D D D
.
ZESH761J
1394 Interface Unit Type 4510
N N N N
Set the dustproof filter cover that
you removed in step
sert the projections on the cover to
the holes on the printer (A A A A ), and
then push it down (B B B B ).
Note
❒ After finishing installation, you
can check whether the 1394 In-
terface Unit is installed proper-
ly. Print the configuration page
f ro m t h e " L i s t / T e s t P ri n t "
menu. If it is installed properly,
you will see "Installed" for
"IEEE1394".
❒ If the 1394 Interface Unit is not
installed properly, "Not In-
stalled" is shown. In such a case,
reinstall from step
not install it properly even after
reinstallation, contact your sales
or service representative.
Reference
See "Using the Control Panel" in
the Administrator Reference for
printing the configuration page.
C C C C
. First, in-
ZESH218J
A
. If you can-
39
1