Ricoh Aficio C2500 Operating Instructions Manual page 61

Problem
Printing does not start.
Printing does not start.
Printing does not start.
Printing does not start.
Data-in lamp does not
blink or light up.
The status indicator of
the printer is lit.
"
Updating the
destination
list... Please
wait. Specified
destination(s)
or sender's name
has been
cleared. " appears.
Cause
If the machine is operating in an
extended wireless LAN, the re-
ceiver's MAC address may be
preventing communication with
the access point.
The extended wireless LAN has
not started.
The login user name, login pass-
word, or driver encryption key is
invalid.
Advanced encryption has been
set using the Extended Security
function.
If the data-in lamp is unlit or not
flashing even after performing
[Print], the machine has not re-
ceived the data.
The cause is displayed on the dis-
play of the control panel.
The destination list is being up-
dated from the network using
SmartDeviceMonitor for Admin.
When You Cannot Print
Solution
Check access point settings when
in the infrastructure mode. De-
pending on the access point, cli-
ent access may be limited by
MAC address. Also, check there
are no problems in transmission
between access point and wired
clients, and between access point
and wireless clients.
Confirm the orange LED is lit,
and the green LED is lit or blinks
during transmission.
Check the login user name, login
password, or driver encryption
key.
Check the settings of the Extend-
ed Security function with the ad-
ministrator.
• When the machine is connect-
ed to a computer via a cable,
check the computer print port
settings are correct. See "Con-
firming the Connection Meth-
od", Printer Reference.
• When it is networked with a
computer, Contact the admin-
istrator.
Check the error message on the
display panel and take required
action. See p.49 "When a Message
appears".
Wait until the message disap-
pears. Do not switch off the pow-
er while this message is
displayed. Depending on the
number of destinations to be up-
dated, there may be some delay
before you can resume operation.
Operations are not possible while
this message is displayed.
4
53