Hyundai 12ESH Operation Manual page 40

If the truck is in operation (transport) and the load block off the sight, when the vehicle is operating, the load
should located on the backward of the truck operation direction.
For example: in some conditions (for example stacking and climbing), when the vehicle is operating, the load
is required on the forward of the vehicle operation direction. Then, the driver should drive the vehicle carefully.
It is necessary to attend: if the operation condition require, should equip accessory (assistant) equipment or
assistant.
The passage, road, runway, floor or slope should maintain good operating conditions, to prevent the truck
or the load from being damaged, and to prevent reducing the stability of the vehicle.
In dangerous state, including the barrier danger on the top should mark on the clear location.
The fire fighting passage, the upstairs passage and the fire fighting equipment should maintain expedite.
14.1.5.2 Gangplank or transition board
All the gangplank or transition board should has enough safety coefficients to bear the truck with load. On
the gangplank or transition board should marked the max passing load perpetually.
The gangplank or transition board should fix firmly, to prevent the accidental move, vibration or slide.
On the gangplank or transition board should equipped handing or other available equipment to the effect of
safety transport. On the conditions of possible, should set the fork hole or suspending ear for moving goods.
The gangplank or transition board should have non-slip finishing.
On the both sides of the gangplank or transition board, should mount the facility to prevent the truck from
going over its edge.
When the gangplank or transition board is fixed its location, should adopt measures to prevent the reverse
joint truck from moving suddenly.
14.1.5.3 Lighting
When the photometric brightness on the operating field is less than 32LX, the vehicle should equipped
auxiliary light.
14.1.5.4 The suspending of the truck
The sling should be tied to the lifting spot which the factory appointed.
14.1.5.5 The synchronizing operation of the truck
Conveying bulky or heavy load using two trucks simultaneously is a dangerous operating which requires
special care. And this kind of conditions should be taken as special conditions and carried out under the
supervision of the operator responsible for operation.
14.1.5.6 Elevator (lifter)
The elevator (lifter) for transporting the industrial truck can bear the overall weight of truck, load and the
drivers. This kind of elevator (lifter) must be appointed, and the drivers should use the appointed elevator
(lifter).
14.1.5.7 Operating on the road vehicle (trailer) and rail vehicle
Before the motor industrial vehicle drive to the road, the road vehicle should apply the brake and wedging
to prevent moving.
Exception: the road vehicle equipped with automatic snap lock type parking brake can not use the wedge.
The industrial motor truck passing in and out without connect to the tractor, to prevent the semi-trailer hold
up can use support.
It is necessary to build up the operating communication and operating order, to prevent the rail vehicle move
accidentally when downloading.
The road vehicle (trailer) and rail vehicle should endure the overall weight of vehicle, load and the drivers. It
is necessary to inspect if the pavement is crushing, having holes or other damage.
When the industrial truck is operating at high place or platform, should not use the industrial truck to move
other vehicles. Never open the door of the rail truck using industrial truck; expect for equipped with special
device and the driver has passed the train to use the device.
14.2 Applied to the driver
The safety operating of the industrial truck lies on the control manner of the driver or a considerable degree.
The safety rules applied to the drives are as follows:
A） general rule;
B） transporting (lifting and stacking) rule;
C） operating (driving) rule;
D） The rule for the driver maintaining the truck.
Without regard to the rules maybe conduce:
A） the serious danger of damaging the driver or other personnel;
B） Damage the materials.
14.2.1 General rule
Only the personnel who have been trained and get the qualification of operation are permitted to drive the
industrial truck.
36