Hyundai 12ESH Operation Manual page 39

When the truck mounted attachment working without load, it should be viewed as partial load.
14.1.4.3 The protection requirement and protection equipment
The truck should painted the color differing from the surrounding circumstance.
The driving type high –lift truck should be mounted with protection cabane, except for the condition where
the load could not drop onto the driver.
When convey the load maybe fall to the driver using high –lift truck, should adopt shielding shelf with enough
height, weight and the opening size is small enough to prevent the entire load or part of them from falling
onto the driver.
When it is necessary to denote the working condition, the truck should add caution device, such as light or
flash lamp.
In the permit of the factory, it is allowed to install turning hand hold on the steering wheel formerly without
it.
14.1.4.4 The transportation and storage of the fuel
The truck should refuel in the stated place. The fuel station should be ventilative, in order to reduce the
accumulation of the fuel gas to the least. In opening pit, subway entrance, and lift well or other similar
conditions nearby should not fill in the liquefied petroleum gas and replace other dismountable liquefied
petroleum gas container.
It is forbidden to smoke in the place of refuel, and should alarm using placard.
If the liquid fuel is not transport using pipeline, it should be transported using airtight container.
Only the personnel trained and appointed can fill or change the liquefied petroleum gas container.
When store and transport the liquefied petroleum gas container, should fasten up the filling valve, and the
safety valve should connected to the vaporization room directly. When storing the container, should screw the
protective cap on the connection mouth.
Before filling and/or reusing, should inspect the container to ensure that it is vapor proof. Especially pay
attention to the valve and the connective part is vapor proof. The damaged container should not be used. Only
the permitted corporation could repair the liquefied petroleum gas container.
14.1.4.5 The charging and changing of the battery
The battery charging station should set in the appointed area. The charging station should prepare the
equipment using for flushing and neutralizing the overflow electrolyte, the fire control device, the measure
avoiding the truck damage the charging device and the adequacy ventilation facility blow away the fume off
from the battery.
In the area of charging, it is forbidden to smoke and alarm with placard.
Only the personnel trained and permitted can change or charge the battery. The battery repairing people
should wear protective clothes.
All the work of changing the battery should carried out according to the description of user's manual from
the factory. When reinstall the battery, should adopt measures to make the battery connecting, orientation
and fixation correctly. Do not put tools and other metal substance on the lidless battery.
Without the special approval (for example the truck factory), the electrical motor truck should not change the
battery with different voltage, weight or size.
It is obliged to use the battery stated by the factory. It is obliged to prepare the facility for changing battery
safely. When hanging up the battery using hoisting equipment, it is necessary to use insulated steeve.
If adopting chain hoist, it is necessary to equip chain box. If adopting chain block, the lidless battery should be
covered by a piece of rubber blanket or other insulated materials, to prevent the short circuit of chain and the
connecting wire or connecting terminal between the battery lattices.
14.1.4.6 The invalid or damaged truck
If finding the motor industrial vehicle existing insecurity factors, it should stop using and give away on the spot.
After repairing and recovery to the safety conditions, it can be reused.
14.1.4.7 Accident
Once the accident happens, for example the staff injures, the truck damages the building or the equipment,
firstly should organize salvage, do best to protect the accident field and report to the governor.
14.1.5 Operating conditions
14.1.5.1 Channel and stacking field
The ground of the operating field should have enough carrying capacity, and it is necessary to maintain it well
not to influence the truck operating safely.
The transporting channel of the truck should have well visual field, and it is easy to turn, and no grade, steep
slope, narrows channel and low roof board. The outline or the borderline must be clear.
In the road where it is easy to meet the stepping truck, the width of the channel should be adjusted.
Advising the grade of the channel should not over 10%, the top and the bottom of the slope should transit
smoothly, to prevent the load vibration or the bottom of the truck colliding the ground.
When the grade is over 10%, installing a sign is advised.
35