Table of Contents
Advertisement
36
en | Installing Roof Parapet and Pipe Mounts
3.3.1
Attach Cover Door
1.
2.
3.
4.
NOTICE! After all wiring is complete, close the cover door and tighten the two (2) captive
screws on the cover door to 10-12 N-m (90-105 in.-lbs) to ensure the Power Supply Box is
watertight.
F.01U.217.818 | 1.0 | 2011.04
Compress the bottom hinge pin by pushing the pin lever down and then rotate it behind
the Hinge Pin Stop. The power box Cover Door provides a Hinge Pin Stop to hold the
bottom hinge open while attaching the door.
24V
NC 24V
GND T XD R XD
C+ C-
GND T XD R XD
Figure 3.2 Align Cover Door Hinge to Power Box
1
Power Supply Box
2
Cover Door
3
Align Top Hinge
4
Align Bottom Hinge
Open the top hinge by pushing its pin lever outward and holding it open.
Note: Both Hinge Pins must be fully compressed to open (unlock) the female hinges of
the Cover Door before proceeding to the next step.
While holding the top hinge pin open, position the Cover Door to the Power Supply Box
and align its hinges.
When the hinges are aligned, release the top hinge pin to engage its mating hinge on the
power box. Then release the bottom hinge pin from the Hinge Pin Stop to complete
attaching the Cover Door to the Power Supply Box.
Installation Manual
o
90
C+ C-
5
Hold Hinge Pin Open
6
Open Position
7
Hinge Pin Stop
AutoDome 100 Series Fixed Camera
Bosch Security Systems, Inc.
Advertisement
Table of Contents
