Bosch AutoDome VG5-162-EC0 Installation Manual page 21

AutoDome 100 Series Fixed Camera
To properly wire the incoming high voltage and the outgoing low voltage lines, refer to this
table:
No.
P101
P107
Table 2.2 VG4-PSU1/VG4-PSU2 Power Supply Box Connections
1.
2.
3.
Figure 2.6 Incoming 115/230 VAC power supply
4.
5.
Figure 2.7 Outgoing 24 VAC power supply
WARNING!
Ensure that you connect the outgoing power supply wires to the P107 heater connectors (HN
and HL). The heater power (XF103) fuse can handle a higher amperage (3.15 A) than the
camera power (XF102) fuse (2.0 A).
Bosch Security Systems, Inc.
Installing the Pendant Arm Wall, Corner, and Mast (Pole) Mounts | en
Connector
Ground
115/230 VAC Power In
Out
24 VAC Power
Route the high voltage 115/230 VAC lines through the conduit fitting on the left side of
the box. The Power Supply Box with a transformer comes with a barrier that separates
the high voltage side on the left, from the low voltage 24 VAC side on the right.
Cut and trim the high voltage 115/230 VAC power and ground wires with sufficient slack
to reach their connector terminal in the box, but not so long as to be pinched by or to
obstruct closing the cover door.
Attach the supplied 3-pin power plug to the incoming high voltage power wires in the
box. Refer to connector P101 in Table 2.2, Page 21 and to the image below for an
illustration of these connections:
P101
24V NC 24V
1 2 3
Attach the ground wire to the grounding screw.
Connect three wires to the P107 Power Out connector to route the 24 VAC power supply
to the VG4-PA0 Power Supply Box.
a. Connect the first wire to pin 5 (HN: Heater Neutral) connector.
b. Connect the second wire to pin 4 (HL: Heater Line) connector.
c. Connect the third wire to pin 3 (Earth Ground) connector.
Refer to connector P107 in Table 2.2 and to the image below for an illustration of
these connections:
Installation Manual
Pin 1 Pin 2 Pin 3
Grounding Screw
Line NC Neutral
Earth
Ground
Pin 4 Pin 5 Pin 6
Heater Heater
(24 VAC) (24 VAC)
F.01U.217.818 | 1.0 | 2011.04
21