Wire The Pipe Interface Board - Bosch AutoDome VG5-162-EC0 Installation Manual

46 en | Installing Roof Parapet and Pipe Mounts
6.
7.
WARNING!
You must thread the Dome Cap onto the pipe until it is tight. Failure to do so can result in
damage or serious injury or death.
3.7

Wire the Pipe Interface Board

This section provides instructions for connecting wires and cables to the Pipe Interface
Board, as illustrated below. Refer to Section 5 Cable and Wire Standards, page 61 for cable and
wiring recommendations and specifications.
Figure 3.10 Pipe Interface Board Connections
F.01U.217.818 | 1.0 | 2011.04
Apply the supplied thread sealant to the threads on the Pipe.
– Make sure all surfaces are clean and dry.
– Apply a bead of sealant completely around the leading threads of the male fitting.
– Force the adhesive into the threads to thoroughly fill all voids.
Thread the Pipe Cap onto the down pipe and tighten securely to prevent leaks. Refer to
Figure 3.9, Page 45.
BNC
AGND
OUT 3
OUT 2
OUT 1
Installation Manual
AutoDome 100 Series Fixed Camera
6
5
4
3
2
1
7
6
5
4
3
2
1
3
2
1
2
1
Bosch Security Systems, Inc.