Renesas RA Family
MCK-RA4T1 Quick Start Guide
4.1.2
Connect the motor and the board
Connect the supplied inverter board, CPU board and motor following Figure 4-3. Also, turn off SW1 on the
inverter board and set VR1 to around the center. The motor is equipped with a Hall sensor signal cable, but
since the Hall sensor signal is not used for quick start operation, it does not need to be connected.
Figure 4-3 Hardware configuration
R12QS0062EJ0100 Rev.1.00
Page 8 of 17
May 23, 2023