Table of Contents
Advertisement
LIGHTING WITH A SPILL
Important do not light with a wax taper
In the unlikely event of the piezo ignition unit failing to light the fire, turn the control
knob to the OFF position, and wait a minute or so for the gas to disperse. The fire
can then be lit by using a spill.
a)
Apply a lighted spill through bottom window of the central radiants.
Light the pilot by depressing the control knob at the "off" position and
turn anti-clockwise (with the control depressed) to the second position
marked *.
b)
When the pilot lights, remove the spill and continue to hold the control
knob down for 10 seconds.
c)
If the pilot fails to light, repeat the ignition sequence and hold in the
control knob for slightly longer.
d)
When the pilot has lit, release the control knob from the depressed
position, depress slightly again and turn the control anti-clockwise to the
high position.
WARNING : Before attempting any cleaning operation ensure that the fire
has been allowed to fully cool.
CLEANING THE DRESSGUARD OR REFLECTOR.
Remove the dress-guard by pulling the location wire out at the top, and lifting
away. See fig. 2 overpage.
Clean the dress-guard or reflector by wiping with a damp cloth, and polish with a
dry duster. DO NOT USE ABRASIVE CLEANERS
CLEANING THE CASE.
Dusting is normally all that is required. But where extra cleaning is necessary, use
a damp cloth.
Supplied By www.heating spares.co Tel. 0161 620 6677
5
Advertisement
Table of Contents
