Data Output; Data Conversion - Raymarine hsb2 Owner's Handbook Manual

Chapter 8: Installation

Data Output

Data is transmitted in SeaTalk and NMEA formats as detailed in Appendix D
and can be used to enhance other equipment as required.
The SeaTalk input/output connection is detailed in SeaTalk Connection on
page 8-25.
The NMEA output connector is a 4-pin connector as illustrated below. The
1.5 m NMEA OUT cable has a ferrite clamp attached to ensure EMC
conformance.
NMEA OUT connector
Pin 2, white
Pin 5, screen
Rear of display
Figure 8-18: NMEA Output Connector

Data Conversion

The HSB Series displays convert some information across the
communications links as follows:
NMEA In to NMEA Out and SeaTalk
SeaTalk to NMEA Out
This enables data received by the display to be passed to other instruments. For
example, if you have a master and a repeater display, you only need to connect
NMEA In to the master display, which will pass the data to the repeater via
SeaTalk.
You can prevent NMEA heading data being bridged onto the Seatalk bus -
refer to Bridge NMEA Heading on page 7-8.
Note: To transfer NMEA data, or to convert the data, the display must be pow-
ered On.
Pin 3, blue
Pin 4, not connected
3 2
NMEA out
4 5
NMEA OUT connector
Pin Pin name Function
2 NMEA_GND NMEA ground
3 NMEA_SIG NMEA data output
4 N/C N/C
5 CGND Screen
*Pin 1 does not exist on this connector
8-29
D4254_1