Chapter 8: Installation; Introduction - Raymarine hsb2 Owner's Handbook Manual

Chapter 8: Installation

Chapter 8: Installation

8.1 Introduction

This chapter provides installation instructions for the HSB Series Color LCD
Display. Simple systems such as that in Figure 8-1 below, or integrated
systems (see Section 8.8) are explained. Details for mounting the HSB Series
LCD Display and connecting the equipment are included.
Scanner
Compass
Figure 8-1:
Note: If you wish to practice using the display before installation, connect a
12V or 24V DC power supply (connecting the red wire via a 6.3A quick blow
fuse to positive and the black wire to negative) and using the simulator mode,
as described in Chapter 2.
If you are connecting your display to other equipment (including another HSB
Series display unit) install then test the display as described in this chapter.
Details on installing the scanner are provided in the Pathfinder Radar
Scanner Owner's Handbook. Once the display is operating correctly, you can
connect it to other equipment as described in Section 8.8, taking particular
care to ensure the correct polarity of the SeaTalk supply. Section 8.8 describes
the HSB, SeaTalk and NMEA interfaces.
Display Unit
NMEA
12/24V Supply
12V Supply
Typical System
Junction
Box
SeaTalk
Distribution Panel
12V Supply
8-1
GPS
D4288-2