Data Output; Data Conversion - Raymarine HSB2 Plus Series Owner's Handbook Manual

8-30

Data Output

Data is transmitted in SeaTalk and NMEA formats as detailed in Appendix D
and can be used to enhance other equipment as required. You can disable the
transmission of individual NMEA output sentences - refer to NMEA Out Set
Up on page 7-9.
The SeaTalk input/output connection is detailed in SeaTalk Connection on
page 8-27.
The NMEA output connector is a 4-pin connector as illustrated below. The
1.5 m NMEA OUT cable has a ferrite clamp attached to ensure EMC
conformance.
NMEA OUT connector
Pin 2, white
Pin 5, screen
Rear of display
Figure 8-19: NMEA Output Connector

Data Conversion

The hsb
links as follows:
NMEA In to NMEA Out and SeaTalk
SeaTalk to NMEA Out
This enables data received by the display to be passed to other instruments. For
example, if you have a master and a repeater display, you only need to connect
NMEA In to the master display, which will pass the data to the repeater via
SeaTalk.
You can prevent NMEA heading data being bridged onto the Seatalk bus -
refer to Bridge NMEA Heading on page 7-8.
Note: To transfer NMEA data, or to convert the data, the display must be pow-
ered On.
Pin 3, blue
Pin 4, not connected
3
4
2
series displays convert some information across the communications
2
hsb PLUS Series Color LCD Display
NMEA OUT connector
Pin Pin name
2 NMEA_GND
3 NMEA_SIG
4 N/C
5 CGND
*Pin 1 does not exist on this connector
2
NMEA out
5
Function
NMEA ground
NMEA data output
N/C
Screen
D4254_1