Power Supply; Using Battery Packs - Sony Power HAD EX DXC-D55PK Operating Instructions Manual

Power Supply

This unit operates on either a battery pack or an AC
supply (using the optional AC-550/550CE AC
Adaptor).
For details of the power supplies which can be used, refer to
the documentation supplied with the VTR connected to this
unit or the camera adaptor.
38
Chapter 2 Fitting and Connections

Using Battery Packs

Always fully charge a battery pack before using it.
Notes
• Be careful that other metal objects do not come in
contact with the metal parts of the battery pack, as
this could cause a short.
• Do not leave the battery pack in the camera if it is not
going to be used for a long time.
• If the battery pack is recharged after use while still
hot, it may not be possible to obtain a full charge.
Battery pack operating times
The following table shows approximate continuous
operating times, when operating the camera and 1.5-
type viewfinder at normal temperatures, with a camera
adaptor and the DSR-1/1P or PVV-3/3P connected.
Battery pack Continuous operating time
BP-GL65 a) about 120 minutes
a)
BP-GL95 about 200 minutes
a) Requires the dedicated BKW-L601 Battery Case when
the PVV-3/3P is attached.
Battery low indications
When the voltage of the supply to the camera head
lowers to or below 11.0 V, LOW BATT appears in the
viewfinder. At this time, the BATT indicator in the
viewfinder flashes when operating with the DSR-1/1P
or PVV-3/3P.
If you continue using the camera head, the BATT
indicator lights up.
When the battery pack is low, replace it with a fully-
charged battery pack.