Fitting To A Tripod; Adjusting The Position Of The Shoulder Pad - Sony Power HAD EX DXC-D55PK Operating Instructions Manual

Fitting optional microphones (operable with a
+48 V supply) other than the ECM-670
Use the same fitting procedure as for the ECM-670,
but note the following differences with respect to the
microphone adaptor.
ECM-672: No microphone adaptor required.
Slender microphones (19 mm (
Use the microphone adaptor supplied with the
CAC-12.

Fitting to a Tripod

First fit the VCT-U14 Tripod Adaptor to the tripod,
then mount the camera on the tripod adaptor.
VCT-U14 Tripod Adaptor
Side the camera forward
along the slot, until it clicks
firmly into place.
Removal
3
/ inch) diameter):
4
Tripod
Hold down the red button
and pull the lever in the
direction of the arrow.
Note
After removing the camera, if the tripod adaptor pin
has not returned to its original position, hold down the
red button and move the lever in the direction of the
arrow to return the pin to its original position. It is not
possible to mount a camera with the pin left out.
Pin
Adjusting the Position of the
Shoulder Pad
The position of the shoulder pad can be adjusted in the
following manner:
1
Loosen the two screws.
Screws
2
Move the shoulder pad forward or backward for
your best fit position.
3
Tighten the two screws.
Chapter 2 Fitting and Connections
33