Table of Contents
Advertisement
b Align the notch on the gold edge of the module with the notch in the memory slot.
c Push down on the memory module with firm and even pressure. The retaining clips will snap into position as
the module is correctly inserted.
Note:
Hold the memory module by its edges, and do not touch the gold connectors.
4 Replace the case and inner panel:
a As you replace the inner panel, connect the cables you unplugged from the inner panel in step 2-c. Make
sure that the Drive Status Indicator connector from the A side should be plugged in the lower port, and that
from the B side in the upper one.
b Replace the inner panel and tighten the 7 screws you removed in step 2-b.
c Replace the top and side covers and tighten the 4 screws you removed in step 2-a.
12 Chapter 2: Hardware Setup
Advertisement
Table of Contents
