Table of Contents
Advertisement
Add a Network Interface Card on DiskStation
Your DiskStation has a PCI Express expansion slot which allows you to install 10GbE or Gigabit network interface
card for LAN port expansion.
1
You need to replace the long bracket (suited for PC) in your network interface card
with the short bracket before installing the card on your DiskStation.
To replace the long bracket with the short one:
1 Unscrew the 2 screws in the long bracket on your network interface card, and then remove the bracket.
2 Replace the long bracket with the short one, and tighten the 2 screws to secure the short bracket.
To install the network interface card:
1 Press and hold the power button until you hear a beep sound to shut down your DiskStation. Disconnect all
cables connected to your DiskStation to prevent any possible damages.
2 Remove the 2 screws on the top of the DiskStation's rear side, and then pull the top cover.
1
For more information about supported 10GbE or Gigabit network interface cards, please visit www.synology.com.
14 Chapter 2: Hardware Setup
Advertisement
Table of Contents
