Table of Contents
Advertisement
To make sure DiskStation recognizes the new memory capacity:
1 Install DiskStation Manager (DSM). (See the next chapter for more information.)
2 Log in to DSM as admin or a user belonging to the administrators group.
3 Check
Total Physical Memory
in
Control Panel
>
Info
Center.
If your DiskStation fails to either recognize the memory or start up successfully, confirm that the memory has
been properly installed.
To remove the RAM Module:
1 Follow step 1 and 2 of the "To install the RAM module" section to shut down your DiskStation, disconnect the
cables, and then remove the case and inner panel.
2 Disengage the memory retaining clips by pushing them outwards, and the module will pop out of the slot.
3 Follow step 4 of the "To install the RAM module" section to replace the panel and case.
13 Chapter 2: Hardware Setup
Advertisement
Table of Contents
