Advertisement
Hardware Installation
General instructions for installing the card are provided below,
since the design of computer cases and motherboards vary. Refer
to your computer's reference manual for further information, if
needed.
Caution: Static Electricity Discharge may permanently damage
your system. To avoid possible static electricity discharge during
the installation, please follow the guidelines below:
• Discharge any static electricity build up in your body by
touching a large grounded metal surface or the computer's case
(if plugged in), for a few seconds.
• During the installation, avoid any contact with internal parts.
Handle cards only by their external edges.
1. Turn OFF the power to your computer and any other
connected peripheral devices.
2. Unplug the power cord from the back of the computer.
3. Remove your computer's cover.
4. Remove the slot bracket from an available PCI slot.
5. To install the card, carefully align the card's bus connector
with the selected PCI slot on the motherboard. Push the board
down firmly, but gently, until it is well seated.
6. Replace the slot bracket's holding screw to secure the card.
7. Replace the computer cover and reconnect the power cord.
Pin Definition, Jumper Settings and Layout
RJ45 10-Pin Pin Definition
Pin #
1
RI or
Signal
5/12V
DSR
DC
2
2
3
4
CD or
RTS
5/12V
DC
5
6
7
Signal
TX
RX
GND
8
9
10
Case
CTS
DTR
GND
Advertisement
