Handlebar Switches - Yamaha CZD300J Owner's Manual

Instrument and control functions
"OIL SERV": Appears when the oil
change indicator "OIL" starts flashing.
If "OIL SERV" is displayed, change the
engine oil, and then reset the oil chan-
ge indicator and oil change tripmeter.
"V-BELT SERV": Appears when the V-
belt replacement indicator "V-Belt"
starts flashing. If "V-BELT SERV" is
displayed, replace the V-belt, and then
reset the V-belt replacement indicator
and V-belt replacement tripmeter.
When there are two or more warnings,
the warning messages are displayed in
the following order:
5
L FUEL → H TEMP → ICE → OIL SERV
→ VBELT SERV → L FUEL

Handlebar switches

Left
1
2
3
1. Dimmer/Pass switch "
2. Turn signal switch "
3. Horn switch "
Right
1. Stop/Run/Start switch "
2. Hazard switch "
3. "TRIP/INFO" switch
Dimmer/Pass switch "
Set this switch to "
beam and to "
To flash the high beam, push the pass
side "PASS" of the switch while the
headlights are on low beam.
Turn signal switch "
To signal a right-hand turn, push this
switch to " ". To signal a left-hand
turn, push this switch to "
released, the switch returns to the cen-
5-11
EAU1234M
/ /PASS"
/ "
"
1
2
3
/ / "
"
EAU54201
/ /PASS"
" for the high
" for the low beam.
EAU12461
/ "
". When