Yamaha CZD300J Owner's Manual page 36

Instrument and control functions
After changing the engine oil, reset the
oil change indicator and the oil change
tripmeter. To reset them both, select
the oil change tripmeter, and then push
the "TRIP" switch for three seconds.
While the oil change tripmeter is flash-
ing, push the "TRIP" switch for 15 to 20
seconds. Release the "TRIP" switch,
and the oil trip value will reset to zero.
TIP
If the engine oil is changed before the
oil change indicator comes on (i.e., be-
fore the periodic oil change interval has
been reached), the oil change tripmeter
must be reset for the oil change indica-
5
tor to come on at the correct time.
V-belt replacement tripmeter "V-
Belt Trip"
1
1. V-belt replacement indicator "V-Belt"
2. V-belt replacement tripmeter
The V-belt
shows the distance traveled since the
V-belt was last replaced.
The V-belt replacement indicator "V-
Belt" will flash every 20000 km (12000
mi) to indicate that the V-belt should be
replaced.
After replacing the V-belt, reset the V-
belt replacement indicator and the V-
belt replacement tripmeter. To reset
replacement tripmeter
them both, select the V-belt replace-
ment tripmeter, and then push the
"TRIP" switch for three seconds.
While the V-belt replacement tripmeter
is flashing, push the "TRIP" switch for
15 to 20 seconds. Release the "TRIP"
switch, and the V-belt trip value will re-
set to zero.
TIP
If the V-belt is replaced before the V-
belt replacement indicator comes on
(i.e., before the periodic V-belt replace-
ment interval has been reached), the V-
belt replacement tripmeter must be re-
set for the V-belt replacement indicator
to come on at the correct time.
Information display
2
1. Information display
The information display is equipped
with the following:
 air temperature display
 battery voltage display
 traction control system display
 average fuel consumption display
 instantaneous fuel consumption
display
 average speed display
 warning message function
5-7
1