Yamaha CZD300J Owner's Manual page 26

Smart key system
trical systems will be switched off,
which may result in loss of control or
an accident.
TIP
Do not push the main switch knob re-
peatedly or turn the main switch back
and forth beyond normal use. Other-
wise, to protect the main switch from
damage, the smart key system will
temporarily disable and the smart key
system indicator light will flash. If this
occurs, wait until the indicator light
4
stops flashing before operating the
main switch again.
The main switch positions are de-
scribed below.
ON (on)
1
1. Push.
2. Turn.
All electrical circuits are supplied with
the power, and the engine can be start-
ed.
To turn the vehicle power on
1. Turn the smart key on and bring it
within operating range.
EAU76500
2
2. Push the main switch knob and
the smart key indicator light will
come on for approximately 4 sec-
onds.
3. While the smart key system indi-
cator light is on, turn the main
switch to "ON". All of the turn sig-
nal lights flash twice and the vehi-
cle power turns on.
TIP
 If the vehicle battery voltage is
low, the turn signal lights will not
flash.
 See "Emergency mode" on page
8-38 for information on turning the
vehicle power on without the
smart key.
OFF (off)
1
1. Turn.
All electrical systems are off.
To turn the vehicle power off
1. With the smart key turned on and
within operating range, turn the
main switch to "OFF".
2. The turn signal lights flash once
and the vehicle power turns off.
4-9
EAU76510