Yamaha CZD300J Owner's Manual page 34

Instrument and control functions
 When approximately 2.4 L (0.63
US gal, 0.53 Imp.gal) of fuel re-
mains in the fuel tank, the last seg-
ment of the fuel meter will start
flashing. The display will automat-
ically change to the fuel reserve
tripmeter "F Trip" and start count-
ing the distance traveled from that
point.
Coolant temperature meter
5
1. Coolant temperature meter
The coolant temperature meter indi-
cates the temperature of the coolant.
If the top segment flashes, stop the ve-
hicle, then stop the engine, and let the
engine cool. (See page 8-37.)
NOTICE
Do not continue to operate the en-
gine if it is overheating.
TIP
 If a problem is detected in the
coolant temperature meter, all
segments will flash repeatedly. If
this occurs, have a Yamaha dealer
check the vehicle as soon as pos-
sible.
 The coolant temperature varies
with changes in the weather and
engine load.
Tripmeter display
1. Tripmeter display
The tripmeter display is equipped with
the following:
1
 odometer
 tripmeter
 time tripmeter
 fuel reserve tripmeter
 oil change tripmeter
 V-belt replacement tripmeter
Push the "TRIP" switch to change the
display between the odometer "Odo",
tripmeter "Trip", time tripmeter "Trip
Time", oil change tripmeter "Oil Trip",
and V-belt replacement tripmeter "V-
Belt Trip" in the following order:
Odo → Trip → Trip Time → Oil Trip →
ECA10022
V-Belt Trip → Odo
Odometer
"Trip"
The odometer shows the total distance
traveled by the vehicle.
The tripmeter shows the distance trav-
eled since it was last reset.
To reset the tripmeter, select it by
pushing the "TRIP" switch, and then
push the "TRIP" switch for three sec-
onds.
TIP
 The odometer will lock at 999999.
5-5
"Odo" and tripmeter
1