Panasonic WX-CC411BP Operating Instructions Manual page 15

Browser Operation
[Sender's E-mail address]
Input the sender's email address. The email address entered
will appear in the "From" line on the email being sent.
Number of characters: 3 to 128
Types of characters: alphanumeric, characters @ . _ -
Default setting: None (blank)
q Setting Network Cameras connected to the
w
unit [Camera]
This tab is used to set Network Cameras displayed on
the LCD display of the Center Module. Setting Network
Cameras enables camera images from vehicle detectors to
be displayed on the Center Module in tandem with security
alerts.
Click the [Installation] button, then the [Camera] tab.
Camera 1 to 4
A maximum of four Network Cameras can be connected
to the Center Module. This section describes how to set
Network Cameras connected to the unit.
Important
w p Network Cameras that can be connected to the
Center Module are Panasonic i-PRO series Network
Cameras.
w p Be sure to set HTTP for the Network Camera
connection method setting.
w p Configure the Network Cameras to the following
settings:
· Aspect ratio: 4:3
· Image quality: standard
[Delete] button
This button is used to restore the Network Camera settings
to the default settings.
[IP address]
Input the IP address of the Network Cameras that are
connected to the unit.
Default setting: None (blank)
[HTTP port]
Input the port number of the Network Cameras that are
connected to the unit.
Settable port numbers: 1 to 65535
Default setting: 80
[Authentication]
Configure this setting if the user authentication setting is set
to "ON".
ON: User authentication will be required when
connecting to Network Cameras.
OFF: User authentication will not be required when
connecting to Network Cameras.
[User name]
If [ON] is selected for [Authentication], input the username
for accessing the Network Cameras.
Number of characters: 0 to 32
Default setting: None (blank)
[User password]
If [ON] is selected for [Authentication], input the password for
accessing the Network Cameras.
Number of characters: 0 to 32
Default setting: None (blank)
q Setting Help contact [Help contact]
w
This tab is used to set the telephone number and configure
the email transmission settings for the Help contact screen
displayed on the LCD display of the Center Module.
Click the [Installation] button, then the [Help contact] tab.
[Telephone]
Input the telephone number. This setting can also be
changed through operations on the Center Module.
15