Panasonic WX-CC411BP Operating Instructions Manual page 12

Browser Operation
q Configuring network settings [Network]
w
This function is used to configure the network settings of the
Center Module.
Click the [Installation] button, then the [Network] tab.
IPv4 Network
[DHCP / Static]
Configure the DHCP setting of the Center Module. This
setting can also be changed through operations on the
Center Module.
DHCP: Operating with the DHCP setting ON.
Static: Operating with the DHCP setting OFF (static IP
address).
[MAC address]
Displays the MAC address of the Center Module.
[IP address]
Set the IP address of the Center Module. This setting can
also be changed through operations on the Center Module.
[Subnet mask]
Set the subnet mask of the Center Module. This setting can
also be changed through operations on the Center Module.
[Default gateway]
Set the default gateway of the Center Module. This setting
can also be changed through operations on the Center
Module.
[DNS Auto / Manual]
Set whether to retrieve the DNS server address
automatically ("Auto") or input it manually ("Manual").
When set to "Manual", the DNS setting must be configured.
When using the DHCP function, if "DNS" is set to "Auto", the
DNS server address will be retrieved automatically. Inquire
with the system administrator for questions about settings.
Default setting: Manual
[Primary DNS server address], [Secondary DNS server
address]
If "DNS" is set to "Manual", the IP address of the DNS server
must be entered manually.
Inquire with the system administrator for questions about the
DNS server IP address.
Default setting: None (blank)
[Line speed]
Configure the network transmission rate setting of the
Center Module. This setting can also be changed through
operations on the Center Module.
Web server
[Connection]
Select the method for connecting to the Center Module.
HTTP: Can only connect by HTTP.
HTTPS: Can only connect by HTTPS.
Default setting: HTTP
[HTTP port]
Set the port number to be used in HTTP.
Settable port numbers: 1 to 65535
Default setting: 80
[HTTPS port]
Set the port number to be used in HTTPS.
Settable port numbers: 1 to 65535
Default setting: 443
Important
w p If Web server settings are altered, the Center Module
will restart automatically.
w p If HTTPS is selected, the Center Module will
automatically generate an SSL server certificate. This
is only compatible with SSL self-certification.
w p The following port numbers cannot be used.
(Excluding the port number set in the default settings.)
20, 21, 23, 25, 42, 53, 67, 68, 69, 80, 110, 123, 161,
162, 443, 995, 10669, 10670
12